We service both gas and electric furnace systems with manufacturer-trained technicians.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Crabtree, OR get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Crabtree, OR carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
We carry manufacturer service manuals for major furnace brands.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Crabtree, OR.
Hot surface ignitors crack over time and simply stop glowing — we test resistance rather than replacing on assumption. This is one of the most requested furnace repair calls we get across Crabtree, OR.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Crabtree, OR.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

A clicking-but-not-lighting pattern is one of the most common furnace complaints we diagnose.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Crabtree, OR to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Crabtree Service